Pushing machine equipment

Pushing machine equipment

Aoguang pipe fitting equipment manufacturers mainly according to the requirements of customers to produce processing forming, in the production of push machine mainly according to the requirements of customers to provide manufacturing forming.

Push machine is the main equipment to make elbow pipe fittings, in the production of mass production production, high production efficiency, low cost, automatic production operation process.

The structure of push machine: push machine host, hydraulic pump station, operating table, motor control cabinet, intermediate frequency power supply, compensation capacitor, water cable, intermediate frequency coil adjustment frame, reactor.

This elbow machine is used for the formation of elbow, the main power is hydraulic cylinder, heating mode is medium frequency heating (in addition to the use of coal stove and natural gas heating)

Push machine itself is a non-standard product, so there is no specific specifications, we can directly customize according to customer requirements

Elbow diameter from 21mm - 1620mm, wall thickness from 3mm - 120mm we can do

Medium frequency heating push machine is mainly used for carbon steel and alloy steel elbow forming, if the product you need is stainless steel elbow, please choose cold push elbow machine

The equipment mainly includes: machine base, main oil cylinder support plate (including main oil cylinder), movable push plate, front support plate, semi-automatic feeding structure, intermediate frequency coil adjustment frame (including intermediate frequency heating coil), intermediate frequency power supply, electrical control system and so on.

Customers in order to push machine, according to customer's demand, our company values most bend model is selected the main pump back, choose automatic feeding, sluice gate, mandrel heated to working temperature began to advance, work speed is adjustable, up to the middle point automatically stop, hydraulic gate lock die, core rod feeding, loosen the gate to the finish line, gate lock began to advance from the stem diameter, note: Main push pump can be used at the same time when working, generally only one can be used. Can also be used to retreat without stopping. Backward pump can not be used at the same time, only one can be started, the other standby. Feeding pump can only be used for feeding. The main oil pump hydraulic system automatically adjusts the pressure, and the auxiliary cylinder hydraulic system automatically adjusts the pressure. Both ends of the stroke of the push machine are equipped with a stroke switch, and the actual stroke should be less than the large stroke, that is, the two ends of the active push plate are left from the actual endpoint of the margin, so as not to run the cylinder piston.