Specification for operation of elbow machines

Specification for operation of elbow machines

No one is allowed to stand at the back of the machine when the elbow machine is operating.Prevent sheet material from being pressed and folded separately at one end.If the workpiece or mould is found to be incorrect during the operation, stop parking and check it.Frequently check the fit of upper and lower molds;Whether the pressure gauge's instructions meet the requirements.Abnormal immediately stop, check the reason and clean up in time.Before turning the machine, it is necessary to place the wooden block on the lower mold below the cylinder on both sides and lower the upper skateboard onto the block.First exit the control system program, and then shut off the power supply.