Tee equipment maintenance and operation introduction

Tee equipment maintenance and operation introduction

The three way equipment needs to be maintained according to the corresponding maintenance standards. Even if the operation is simple, the three way machine also needs to be maintained and nursing, to fundamentally prevent mechanical failure and ensure the smooth progress in the production process.Tee machine equipment in the production process, found that severe wear and tear parts to be replaced, regular protection personnel to the three machinery maintenance and protection, such as adding lubricating oil, etc.Finally, in the sliding side in the production process of smooth manufacturing and production of three-way pipe fittings, so as not to prevent the oxidation and rust of the three-way machine, especially in the case of long-term idle, do a good job in the maintenance of details, the normal work of the three-way machine equipment is very good, together also can ensure the smooth production.

In the daily maintenance process, it is important to be careful, whether it is about all the work of the three-way machine equipment, or about the replacement of some parts, it is necessary to regularly check the wear situation, especially in the production process, pay more attention to these parts, in order to prevent severe wear and tear from affecting the production process.If the manufacturer of three-way machine wants to reduce the wear of parts as far as possible, and does not affect the production together, three-way machine equipment downhill forming can significantly reduce the marginal extension.

Tee machine molding operation, increase the quantity of the open pass, is slightly less than the thickness of roll gap between the upper and lower roller, namely the central tube billet by trace calender, an extension of the larger in the central, to reduce the relative elongation of the marginal if central extension is greater than the marginal extension, is now at the exit twist up, if less than the marginal extension, is winding down, adjust the operation should be flat as well.The central extension adds the deformation of the forming machine, so that the power consumption is added, the roller wear is severe, the equipment is simply damaged, and when the tube billet and the roller surface have a relative slide, the roll marks and scratches simply occur.

2289