Cleaning method of pipe bending machine

A pipe bender is a mechanical device for bending metal pipes, widely used in a variety of manufacturing processes, such as automotive, aviation, machinery and piping industries. Due to frequent use, the pipe bender needs regular cleaning to ensure its normal operation and maintain the high efficiency of production. This article will introduce the cleaning method of the pipe bender in detail to ensure its long-term reliable operation.

First, the preparation before cleaning

1. Ensure that the pipe bender is turned off and powered off.

2. In order to avoid accidents, explosions and fires, please use appropriate protective measures when cleaning. Wear appropriate protective clothing, such as gloves, stability boots, and helmets.

3. Remove all pipes, nuts, gaskets and other parts.

4. Ensure that all oil and liquid are discharged from the pipe bender and are in a stable state.

Second, pipe bending machine cleaning steps

1. Clean the surface of the pipe bender

First, the surface of the pipe bender needs to be cleaned. Use a soft cloth or sliding brush and warm water to gently wipe the entire machine to remove dust and grease. If there is a stuck stain on the surface, it can be cleaned with a main cleaner.

2. Clean the inside of the pipe bender

Next, you need to clean the inside of the pipe bender. Place the cone bit into the pipe bender, rotate the bit and spray compressed air to remove dust and grease. Then vacuum up all the impurities. Make sure the cleanup is thorough, especially around the oil lines and pumps.

3. Clean the filter of the pipe bender

Pipe bender filters need to be cleaned regularly. Remove filter core from filter and clean. The chip can be cleaned with warm water and soap. Do not use chemicals that will damage the filter. Reinstall the clean chip and then you can turn off the filter.

4. Clean the pipe bender water tank

The tank of the pipe bender must be cleaned frequently to ensure that there are no impurities and sediments in it. Drain the tank water, clean it with detergent, and then rinse it off with clean water. This avoids rust and corrosion and keeps the water in the machine tank pure.

5. Clean the pipe of the pipe bender

Finally, the pipe of the bender needs to be cleaned. Break it down and lay it out, then wash it along the line with warm water, soap or detergent. Use a soft brush to clean more complex or hard-to-reach areas. After cleaning, you need to reassemble and connect the pipes.

6. Lubricate the parts

Specific parts of the pipe bender need to be coated with oil or grease before operation. The use of lubricants can increase machine efficiency and reduce friction.

In short, the pipe bender is an important mechanical equipment that needs to be cleaned frequently to ensure its normal operation and extend its life. The above cleaning process needs to strictly comply with the stability regulations to avoid accidents.

For more knowledge about pipe bending machine, please pay attention to our website:http://www.aocmachine.com/