Medium frequency pipe bender suddenly stop how to do?

Medium frequency pipe bending machine is a kind of mechanical equipment for making metal pipe bending. If the medium frequency pipe bender suddenly stops, it may be a failure caused by a variety of reasons. Here are some common faults and workarounds to help you resolve the problem.

1. Check the power supply and power line: First, ensure that the power plug of the medium frequency pipe bender has been correctly inserted into the power socket, and check whether the power line is working normally. If there is a problem with the power line, you can replace the power cord or repair the power line.

2. Check the electronic components: If the power supply and the power line are normal, then the electronic components of the medium frequency pipe bender may be faulty. You can check the main control board, electronic controller, capacitor, etc. for loosening, burning, or damage. If faulty electronic components are found, they can be replaced or repaired.

3. Check the transmission system: The transmission system may fail, causing the intermediate frequency pipe bender to stop. You can check gears, belts, chains and other transmission components for looseness, wear or breakage. If a problem is found, it can be repaired or replaced.

4. Check the hydraulic system: medium frequency pipe bender usually uses the hydraulic system to generate enough power for bending operation. If there is a problem with the hydraulic system, it may cause the machine to stop. You can check whether the hydraulic oil in the tank is sufficient, whether the hydraulic pump is operating normally, whether the tubing is leaking, and so on. If a problem is found, you can add hydraulic oil, repair the pump, or replace the tubing. '

5. Check the mechanical structure: the mechanical structure of the medium frequency pipe bending machine may be worn and loosened due to long use time. You can check the various parts of the machine, such as sliders, guides, bearings, etc., to see if they need lubrication or adjustment. If serious wear or loosening is found, the corresponding parts can be replaced or repaired.

6. Check the switch and protection device: the medium frequency pipe bender is usually equipped with a stable switch and protection device to ensure the safety of the operator. If these switches and devices fail, the machine may stop. You can check that the switches and protection devices are working properly, and if there is a problem, you can repair or replace them.

7. Contact technical maintenance personnel: If you are unable to determine the cause of the failure of the medium frequency pipe bender or cannot solve the fault, it is recommended that you contact technical maintenance personnel. They have the relevant technical knowledge and experience to better diagnose and repair faults.

In short, the sudden shutdown of the medium frequency pipe bender may be caused by the failure of the power supply, electronic components, transmission system, hydraulic system, mechanical structure or safety switch. By examining these possible sources of failure one by one and taking appropriate solutions, you should be able to solve the problem of downtime of the medium frequency pipe bender. If the problem persists, it is recommended that you seek technical repair help.

For more information about medium frequency pipe bending machine, please pay attention to our website:http://www.aocmachine.com/