Cold push pushing machine

The cold push machine mainly includes a frame, a working table, a side working table, an oil press, a fuel tank, an electrical box and a control panel, as well as a forming mold, a mold lifting device and a stripping device.The frame is a whole frame structure.The hydraulic press includes a vertical hydraulic press arranged vertically between the columns and a horizontal hydraulic press arranged horizontally between the middle part of the columns.The motor of the hydraulic press is arranged on the upper part of the machine.A large flow low pressure pump set is added on the upper part of the machine to connect the vertical compression cylinder to make the cylinder move quickly.The electrical box and control board control the operation of the machine by computer and microcomputer.The utility model reduces the noise and the arrangement of each component is more compact and reasonable.

Cold push machine is mainly used for stainless steel elbow molding. If you need carbon steel or alloy steel elbow, please choose medium frequency heating elbow machine

Elbow cold push molding machine

First, fix and relax the bending machine clamping die base, then put the control panel in manual form, press the clamping button until the end of the clamping operation.At the moment, there needs to be a gap between the wheel mould and the bun, so the screw can be adjusted in the bun.

Adjust the screw of jia Mo seat to make jia mo fully close to the wheel mold.

Press the button of "back clip" to make the mo retreat, and then rotate the adjusting screw clockwise for the mo about 1/2 to 1/4 turn.

Fix the nut lock in jia Mo.These are some of the ways to adjust the cold push elbow machine, just try it.

Cold push elbow machine is used for elbow formation, the main power is hydraulic cylinder, there are two forms, ball type and mandrel type

The main characteristic of the cold-push elbow machine is its low cost, low efficiency and much labor

Mandrel - type cold - push elbow machine is characterized by high cost, but high efficiency, and save manpower

Cold push elbow machine suitable for the production of 21mm- 530mm,1D, 1.5d stainless steel, carbon steel elbow.

The cold push elbow machine itself belongs to non-standard products, so there is no specific specifications and models, we can directly customize according to customer requirements

We can make elbow diameter from 21mm to 630mm and wall thickness from 3mm to 30mm.