A pipe bender is really completed after the bender mold is installed.Whether it is hydraulic pipe bender or numerical control pipe bender, the installation of pipe bender mold should pay attention to safety.

The installation of pipe bender mold is a very important matter.The die installer must have the knowledge to operate the pipe bender and adjust the pipe bender properly, which puts a strain on the quality of the pipe.The mould must be applied to the size of the machine. If the pipe fitting is bent larger than the original value, the excessive load of the machine will result in the failure of the machine performance, and seriously will also endanger the staff who hold the operation.

Do not place any part of your hand, finger or body in the mold running area when the oil pump motor is started.

Do not place, adjust or move a mold without reading or knowing the mold installation instructions in the manual.

Do not wear ties, jewelry or loose clothing while the event is taking place or near the machine.

If the mold is too heavy to be lifted by hand, proper machine lifting points should be used.A lifting ring should be arranged on the mold, and the lifting ring is used to connect the mold parts to stabilize on the way of hanging.

Mold should be cleaned before installation, and remove dust, metal cutting or other foreign dirt.Otherwise, it will cause the inconformity of the signs of the standing room, which will cause the injury of the staff or the destruction of the machine and mold.

In order to carry out differential control, please confirm whether the selector switch setting is accurate before changing the control setting of the pipe bender.And before the implementation of the circumventing matter, please first test to make sure that the operation is correct.

Bend pipe lubricating oil will make the surrounding area slippery, and dirty the mold area to be vigilant with the mold, in the bending pipe coated with absorbent coating at the end, insert the mold safe and practical use of the category, to prevent the bend pipe lubricating oil dripping on the machine.

The installation method of the pipe bender is what each customer needs to collect when ordering the pipe bender. Through the above simple introduction of the installation of the pipe bender, I believe that many customers will know a lot in the installation process of the pipe bender after ordering the pipe bender.