Medium frequency pipe bender pipe bending machine

This medium frequency pipe bender is used for the formation of pipe bending. The main power is hydraulic cylinder or chain drive. The heating method is medium frequency heating

Medium frequency pipe bender itself belongs to the non-standard products, so there is no specific specifications and models, we can directly customized according to customer requirements

We can do the bending tube diameter from 21mm to 1620mm, wall thickness from 3mm to 100mm

Medium frequency pipe bender can be used for carbon steel, alloy steel, stainless steel steel pipe of any material

Intermediate frequency pipe bender bending center Angle is bigger, pipe line segment continues to be the tail did a tangent point B and winding deformation, because of the restriction of fiber effect, close to the tangent point B linear deformation degree increasing, place the shaped pipe unloading, back from the front line carrying, deformation area and cost on the pipe winding deformation load to add winding will no longer like central Angle is smaller.

Twists and turns, however, central Angle increases continuously, has formed the strain hardening effect of the stress in not less than the existing level change, and to avoid twists and turns of pipe elastic recovery, briquetting exert more pressure on pipe fittings, and pipe inside wall thick add reducing the gap between the mandrel and tube, pipe fitting straight line movement more difficult, and then increased the resistance of the winding pipe rolling.The head of other cylindrical mandrel can not be zigzag, and the supporting effect margin of zigzag section is limited. The inductive effect of these elements will make the external load accepted by the pipe section continue to increase, and the distortion degree will further increase